Skip to main content
All CollectionsRuijie Networks / Reyee
Configure VLAN on Ruijie ES Switch
Configure VLAN on Ruijie ES Switch

Step-by-Step Explanation of Setting Up a Layer 2 VLAN on an Ruijie SMB ES Switch

E
Written by Engineering
Updated over 10 months ago

This configuration is specifically for the following ES devices:

Introduction

What is a VLAN?

VLANs (Virtual LAN), also known as Virtual Local Area Networks, are a networking technology that allows the creation of independent logical networks within the same physical network.

How to configure VLAN on Ruijie Routers?

  • Ruijie - Router SMB - Creación de VLAN

  • Ruijie - Router RG-EG3230 - Crear VLAN

Connection diagram

Configuration

1.- The first step is to access the device, which has the following default information:

  • IP: 10.44.77.200

  • Username: admin

  • Password: admin

Note: If the switch is under an SMB router, the equipment will inherit the username and password from that device, and it will also obtain an IP via DHCP.

2.- Within the interface, navigate to the following path to create the VLAN ID: VLAN

Settings -> VLAN Members

Having completed the above steps, it will appear as follows:

3.- Now, go to the VLAN Settings section to configure the ports:

Trunk Port (To receive the VLAN from the switch):

  • Port: 16

  • VLAN Type: Trunk

  • VLAN Native: VLAN 1

  • Permit VLAN: Select all.

  • Click 'SAVE' to save the configuration.

Access Port (To untag the VLAN):

  • Port: 1

  • VLAN Type: Access

  • Access VLAN: VLAN16

Click 'SAVE' to save the configuration.

Having completed the above steps, it will look like this:

With this, the configuration is complete.

Verification

Connect the device to the port where you untagged the VLAN to receive an IP from that segment.

Do you want to perform any other configuration on this range of switches? You can refer to any of these manuals:

Did this answer your question?