When the wireless bridges and the Air metro series are brand new and out of the box, you can access the eWeb interface using the following IP address: 10.44.77.254.

Configure an IP address for the management PC in the same network segment as the default IP address of the device (The default device IP address is 10.44.77.254, and the subnet mask is 255.255.255.0.) so that the management PC can access the device For example, set the IP address of the management P C to 10.44.77.10

Note: The IP address of the management PC cannot be set to 10.44.77.253, because this IP address is reserved by the device. If the management PC uses this IP address, it cannot access the device.

Enter the IP address (10.44.77.254 by default) of the bridge or air metro series in the address bar of the browser to open the login page.

This will display the eWeb interface, allowing you to configure the wireless bridge

On the web page, enter the password and click Login to enter the web management system.

A username is not required on your first login. You can enter the initial password "admin" to log in, and directly start the configuration after login.

For device security, you are advised to set the management password after your first login to the web management system. After the password is s et, you need to enter the password when you log in to the web management system again.

The login page will be locked for 60 seconds if you enter incorrect passwords multiple times. You can press and hold the Reset button on the device for more than 10 seconds when the device is powered on to restore it to factory settings. After the restorati on, you can use the default IP address and password for log in.