Installation Diagram
Bolt Lock (Normally Open)
Magnetic Lock (Normally Close)
How to Set Up the Doorbell (Main)?
You need to enter the local IP address of the main doorbell to do the following configuration.
Enter the doorbell's IP address and log in:
1. Click "Config."
2. Under "Intercom," select "Number Configuration."
3. Under "Device Type," select "Main Door Station"
4. Enter "0" for "Door Station No." as this indicates it will be the main doorbell.
You need to enter the local IP address of the slave doorbell to do the following configuration.
Under the doorbell IP address and after logging in:
1. Click "Config"
2. Under "Intercom," select "Number Configuration."
3. Under "Device Type," select "Sub Door Station"
4. Enter "1" for "Door Station No." as this indicates this will be the primary doorbell.
You'll need to repeat the above configuration if you have more doorbells.
An installation supports up to 10 doorbells (1 main and 9 slaves).
How to add a card reader as an exit device?
Enter the doorbell's IP address.
1. Go to "Config"
2. Select "Wiegand Config" under "Doorbell"
3. Configure the device as shown in the image below:
How to add cards to the doorbell?
Enter the doorbell's IP address.
1. Click "Config"
2. Under "Face," select "People Management."
3. Click the "+" symbol to create a new user.
4. Enter all user information.
5. Click "Card NO." and swipe your card through the doorbell reader. The card information will be automatically filled in.
6. Click Entry.
* If you want to see the users registered with the doorbell, click the "Search" button.
** The doorbell only supports MIFARE cards.
How to add the doorbell to the indoor station?
Directly on the monitor screen:
1. Click on the settings option:
2. In the options on the right, select the option marked with three dots (...)
3. Click on the "Configuration" option and enter the access password.
4. In the "Indoor Station Type" option, select "Indoor Station" as this is the main monitor and in "Room No." enter the room number; in this example, we used "101".
5. Click on the camera option as shown below:
6. In the "Main Door Station" option, enter the IP address of the main doorbell.
In this example, the main door station have the IP Address : 172.16.10.246.
With these steps, the main doorbell and slave doorbell will be linked to the main monitor.
How to add additional monitors as an extension?
Directly on the monitor screen:
1. Click on the settings option:
2. In the options on the right, select the option marked with three dots (...)
3. Click on the "Configuration" option and enter the access password.
4. In the "Indoor Station Type" option, select "Indoor Extension" and in the "Indoor Extension No." enter the extension number; in this example, we used "1".
5. Click on the camera option as shown below:
6. In the "Indoor Station" option, enter the IP address of the main monitor.
In this example, the main Indoor Station (monitor) have the IP Address : 172.16.10.163
** To add more extensions, simply repeat the steps above and change the extension number (Step 4)
