Users can open doors conveniently via the Bluetooth-enabled SmartPlus App.
vc
The following three modes are supported:
Shake: Open the door by shaking the mobile phone near the door phone.
Hands-free: Open the door when the mobile phone is within the pre-defined range set on the door phone.
Tap as Card: Open the door by placing the mobile phone on the door phone’s card reader area.
Note
The following device models support opening the door via Bluetooth:
S539, S532, R29C, X916, X915 V1/V2, X916, E12 V1/V2, E16C, E18C, A03, A05, and A08.ONLY X912, S532 and A03 support Hands-free mode.
ONLY X912, A03 and A08 support Tap as Card mode.
Shake and Hands-free
[Optional]Set Trigger Distance for Hands-free Mode
The trigger distance between the door phone and the mobile phone in Hands-free mode is adjustable.
Take X912 as an example.
Use the device’s IP to log into its web interface with the username and password. The default is admin.
Go to the Access Control > BLE interface. Enable the BLE function and Hands-free mode.
Select the trigger distance: Within 1 Meter, Within 2 Meters, and Within 3 Meters. The trigger distance is 3 meters maximum.
Click Submit to save the settings.
Tip
The Bluetooth door opening in Hands-free mode is affected by the following factors:
The Bluetooth signal strength of mobile phones.
The presence of an obstacle between the mobile phone and the device.
The texture of bags or pockets where the phone is placed.
When encountering door opening failure, try putting the mobile phone somewhere else to reduce the barrier between it and the door phone.
Tap as Card
Note
ONLY the following device models with specific firmware versions support this mode:
A03 with the firmware version 103.30.10.19 and above;
A08 with the firmware version 108.30.1.102 and above;
X912 with the firmware version 912.30.10.210 and above.
SmartPlus App version 6.71.0.9 for Android system and version 6.71.4 for iOS system support this mode.
Take X912 as an example.
Use the device’s IP to log into its web interface with the username and password. The default is admin.
Go to the Access Control > BLE interface. Enable the BLE function. Whether the Hands-Free mode is enabled does not affect the Tap as Card function.
On the SmartPlus App, tap Me > Authorization. Enable Bluetooth Unlock and select Tap as Card as the unlock mode.
Tip
To ensure successful unlocking, it is recommended granting persmissions to SmartPlus App through Permission Settings.
The door will be opened when users place their mobile phones on the door phone’s card reader area.
Tip
Make sure the card reader module of the mobile phone is close to that of the door phone.